Run an export
1
Choose your patients
Under Patients from, pick one of two ways to build the list. You can also add people one
by one with Find patients, and combine both.
2
Check the matches
Each person is matched against your organization’s patients. Fix or remove any that did not
match (see below).
3
Choose the documents
Pick the Document types and the Date range to include.
4
Start the export
Press Start export. You can leave the page while it runs and come back to it from
History.
5
Download the ZIP
When the export finishes, press the download button to get your ZIP.
Build the patient list
Skip the roster if you only want to add patients by search.
Check the matches
After you build the list, patients are grouped:Choose document types
Under Document types, select the kinds of documents to include.- Use Select all and Clear all to change the whole selection at once.
- When you select types, the ZIP has a folder for each patient, with a sub-folder for each document type.
- When you select no types, every document is exported, and the ZIP has one folder per patient with no sub-folders.
- Documents without a type (such as medications and immunizations) are only included when no types are selected.
Choose a date range
Under Date range, only documents dated within the window are included.While the export runs
The export goes through three steps, shown on the page.
Large lists can take 20 minutes or longer. You can leave the page, because the export keeps running and stays listed in History. Press Check status to refresh the page.
Download earlier exports
The History tab lists finished and running exports for your organization. Open an export to download the ZIP again, or the original roster you uploaded.If an export does not finish
When an export finishes, the page shows how many patients completed, for example “19 of 20 patients done”.